HW-B matched with 15KV-2 type electrostatic bar eliminating static electricity on plastic

Main Features

• The effects of eliminating static electricity are to be tested as the best among the active static discharge eliminators.
• Consistent, uniform winding gives a more robust and stable performance.
• More powerful static neutralization, lower electrical stress, and increased reliability.
• Imported capacitor with good pressure-resistant and temperature-resistant.
• Easy to install and operate.
• Adopt a dry type high voltage transformer, which overcomes the easy short circuit and sparking of epoxy resin casting high voltage transformer.

HW-B matched with HW-Ⅱ15 dry type static eliminator

Please check the generator link for more details.

User Attention

1. This machine outputs a high voltage, and non-professionals should not disassemble and maintain it by themselves. Please cut off the power supply for 5 minutes before maintenance to avoid the risk of electric shock.

2. Please read the manual carefully before installation. The ground wire connection end of the controller must be connected to the ground end of the electrostatic bar and reliably connected to the ground.

3. Please install the static elimination rod correctly as shown in the figure below to ensure the reliable connection of the high-voltage line and the generator. The wiring of high-voltage lines should be avoided as close to the metal parts of the machine as possible, and the length should not be too long, so as to reduce the loss of high-voltage lines.

Tips: Neutralise Immediately Before the Problem

There may be several positions in a process where static may be generated. If you neutralize the static too early, it could regenerate as it passes over rollers or through other processes. So, position the static eliminator to neutralise the material at the last possible position before the problem area.